Trash Chute New York | Free Shipping

Whether you're gutting a Brooklyn brownstone, stripping shingles off a Buffalo rooftop, or demoing a Manhattan high-rise, a trash chute in New York is one of the most practical tools on the job. EasyChute ships our lightweight, woven coated-poly fabric debris chutes directly to job sites across the state — from the Bronx to Albany to Long Island — with free shipping on every order.

New York's building stock is some of the most varied in the country: century-old row houses and triple-deckers in the outer boroughs, mid-rise co-ops in Westchester, waterfront condos on Long Island, and dense mixed-use blocks throughout the five boroughs. Each one creates the same basic problem — debris on upper floors, dumpster at street level — and a fabric chute solves it without cranes, outriggers, or a rental crew.

Trash chutes shipped free to New York

Free shipping on every order. See the full shop.

Roofers using EasyChute to drop shingles into a dumpster in Dorchester, Boston

Why New York Crews Rely on a Fabric Trash Chute

Space is tight on most New York job sites. Sidewalk sheds eat the curb lane, neighboring buildings share party walls, and building managers watch every scuff mark in the hallway. Hauling debris down flights of stairs in buckets is slow, hard on your crew, and leaves a trail of dust. Dropping material from a window without a chute is a liability — and above 20 feet, it's an OSHA violation.

A fabric debris chute solves all three problems. It channels drywall chunks, plaster and lath, roofing shingles, wood scraps, and insulation straight from the work floor into a dumpster below — no extra hands needed to guide the load, no debris raining onto a sidewalk shed or a passerby. Our chutes fold down to the size of a sleeping bag when not in use, so they ride in a van or go up a narrow staircase without drama.

For more detail on brownstone and row-house setups, see our guide to brownstone window debris chutes in Brooklyn, or read about running a debris chute on a multi-unit Queens renovation.

OSHA's Enclosed-Chute Rule and New York Job Sites

OSHA 29 CFR 1926.252(a) is straightforward: when construction material is dropped more than 20 feet to any point outside a building's exterior walls, an enclosed chute must be used. On a New York brownstone that's four or five stories, that threshold is crossed on the second or third floor. Every EasyChute section meets or exceeds that OSHA standard.

Beyond federal OSHA rules, New York City and other municipalities may have additional site-safety requirements. Always check with your local building department and site-safety manager before you set up any chute system. Never assume local rules match the federal baseline.

Choosing the Right Chute Length for New York Buildings

New York's building heights vary more than almost anywhere else in the country. Here's how to size your order:

Two- and three-story row houses (outer boroughs, upstate cities): A single 25 ft section covers the full drop from a top-floor window to street level and then some. At under 8 lbs it goes up in one trip.
Four- to five-story brownstones and walk-ups: Two 10 ft heavy-duty sections connected with carabiners, or one 25 ft section, typically handles the run. For a five-story drop, our 50 ft section covers it end to end.
Mid-rise co-ops and condos (six to ten stories): Stack a 50 ft section with one or two 10 ft sections. Sections connect loop-to-loop with carabiners; every joint overlaps 1.5 feet to keep dust and debris contained inside the chute.
High-rise gut rehabs in Manhattan or downtown Brooklyn: Multiple 50 ft sections can be chained together for very tall drops. Middle shortening straps on each section let you dial in the exact length you need so the chute mouth sits right at the dumpster.

Not sure what you need? Visit our full chute shop or call us at 855-902-4883, Monday through Friday, 8 AM–10 PM Eastern.

Working Through New York's Climate

New York gets all four seasons in full force — cold, snowy winters upstate and in western New York, humid summers in the city, and shoulder seasons that can swing either way. Our chutes are made of woven, coated poly fabric that is tear-resistant and built for the rough handling of a real job site. Store sections in a dry location when the chute is not in use and inspect connection loops before each setup. That's the same common-sense care you'd give any job-site gear in variable conditions.

Setting Up Your EasyChute on a New York Job Site

Setup is designed to be a one-person job. Here's how it works on a typical New York row house or brownstone:

Rig the top anchor. Hang the top section from a window frame, roof edge, scaffold pipe, or fire-escape rail using the four woven loops at the top of the chute. No outriggers or special hardware required.
Make a hopper (optional but helpful). A standard 32-gallon commercial trash can with its bottom cut out fits over the top of the chute and acts as a funnel, making it easier for your crew to feed debris without spillage.
Add sections as needed. Connect additional sections loop-to-loop with carabiners. Each joint overlaps 1.5 ft automatically, so nothing escapes at the seams.
Adjust the length. Use the middle shortening straps on each section to set the final length so the chute mouth drops right into or just above your dumpster.
Load from the work floor. Feed drywall, plaster, shingles, and wood scraps directly into the chute. Debris travels down to the dumpster below — no extra hands, no dust cloud in the stairwell.
Break it down. When the job is done, disconnect the sections, fold each one down, and store them. A 10 ft section weighs under 3 lbs and fits in a drawer or small box. The chute is fully reusable job after job.

For a detailed setup walkthrough on a split-level or multi-story house, see our Long Island split-level debris chute setup guide.

EasyChute Products and Pricing

Every section ships free to your New York job site — city address, suburban driveway, or upstate work site. Order at fixed prices, no haggling required.

EasyChute Lite-Duty Trash Chute — 10 ft Section — $99
EasyChute Heavy-Duty Trash Chute — 10 ft Section — $149
EasyChute Trash Chute — 25 ft Section — $277
EasyChute Trash Chute — 50 ft Section — $596

Browse everything in the EasyChute shop, or reach us at our contact page if you have questions before you order. Have a look at our FAQ for answers on sizing, setup, and connecting multiple sections.

Order Your Trash Chute — Shipped Free to New York

EasyChute is a Massachusetts-made product built by remodeling contractors who understand job-site reality. We ship to job sites across New York — Manhattan, Brooklyn, Queens, the Bronx, Staten Island, Long Island, Westchester, Buffalo, Rochester, Albany, and everywhere in between. Order online today and we'll ship directly to your site.

Frequently asked questions

Do you ship trash chutes to New York City job sites, including Manhattan and Brooklyn?

Yes. EasyChute ships free to job sites anywhere in New York State, including all five boroughs of New York City. Just enter your site address at checkout and there's no added shipping cost.

Which chute length works best for a four-story New York brownstone?

A 25 ft section typically covers a three- to four-story drop from a top-floor window to street level. For a full five-story drop, step up to the 50 ft section. You can also stack two 10 ft sections for a shorter run and add more as needed.

Does using a trash chute satisfy OSHA's enclosed-chute requirement on New York job sites?

Every EasyChute section meets or exceeds OSHA 29 CFR 1926.252(a), which requires an enclosed chute when debris is dropped more than 20 feet outside a building's exterior walls. New York City and other municipalities may have additional site-safety rules, so always verify requirements with your local building department and site-safety manager.

Can I hang the chute from a fire escape on a New York building?

The chute's four top loops can anchor to a fire escape rail, a window frame, a scaffold pipe, or a roof edge — whatever is most practical for your site. No outriggers or special rigging hardware are needed. Make sure the anchor point is rated for the load and check with building management or your site-safety plan before rigging to a fire escape.

Can I reuse the chute on multiple New York projects?

Absolutely. EasyChute sections are designed to be reused job after job. Each 10 ft section weighs under 3 lbs and folds down small enough to store in a van or a job-site bin, so moving them from one New York project to the next is no trouble at all.

Trash Chute New York: Ship to Any Job Site, Free