Trash Chute Bronx | Free Shipping

When you're tearing out a kitchen in Tremont, stripping a roof in Riverdale, or gutting apartments in Co-op City, you need a trash chute in the Bronx that keeps debris moving safely from upper floors to the dumpster below — without tying up your crew or blocking a narrow sidewalk any longer than necessary. EasyChute ships lightweight, woven coated-poly fabric debris chutes free to job sites anywhere in the Bronx, so you can order today and get to work.

The Bronx is one of New York City's densest and most architecturally varied boroughs. You'll find six-story elevator apartment buildings along the Grand Concourse, three-story walk-ups and attached rowhouses in Fordham and Bedford Park, detached colonials in Pelham Gardens, and large prewar co-op complexes in areas like Co-op City. Every one of those building types creates a different chuting challenge — different heights, different setups, different amounts of debris. EasyChute is designed to handle all of them with a single, reusable system that connects section by section to match whatever height your project calls for.

Trash chutes shipped free to the Bronx

Free shipping on every order. See the full shop.

An orange EasyChute trash chute hanging from a brownstone renovation in New York City

Why the Bronx Calls for a Fabric Debris Chute

In a borough where parking is tight, sidewalks are narrow, and neighbors are close, a rigid steel chute frame can be more trouble than it's worth. EasyChute's fabric trash chute hangs directly from a window frame, roof edge, scaffold railing, or fire escape — no outrigger, no rental frame, no hoist crew. The entire system folds down small enough to carry up in a bag. A 10-foot section weighs under three pounds. A 50-foot section weighs under fifteen.

That matters on a Bronx job site. When you're working in a building with a single service elevator, or hauling equipment up a six-floor walk-up staircase, every pound and every cubic foot of gear counts. EasyChute goes up fast and comes down just as fast at the end of the day.

For debris containment, the chute's 22-inch diameter handles the typical output of a renovation crew — drywall sheets, plaster and lath, roofing shingles, wood scraps, insulation batts — moving it cleanly from upper floors to a dumpster or trash can below. Every section connects to the next with carabiners or quick-connects through four woven loops at the top and four at the bottom. Each joint overlaps 1.5 feet so dust and debris stay inside the chute instead of dusting the sidewalk or a neighbor's window.

OSHA Requirements and the Bronx Building Environment

OSHA regulation 29 CFR 1926.252(a) is clear: when material is dropped more than 20 feet to any exterior point outside a building's walls, an enclosed chute must be used. In the Bronx, where a two-story drop puts you at roughly 20 feet and a six-story prewar puts you well past 60 feet, that rule applies to a wide range of everyday renovation work. EasyChute meets or exceeds applicable OSHA regulations, so you can keep your project compliant without renting specialty equipment.

Always check with the New York City Department of Buildings and your local Bronx building department for any site-specific permit or safety requirements before starting work. Rules can vary by project type, building class, and street location.

Choosing the Right Section Length for Bronx Buildings

EasyChute sections are sized to match common building heights. Use the guide below to configure your chute before you order:

One-story rowhouses and garden-level apartments — A single 10-foot Lite-Duty section ($99) or 10-foot Heavy-Duty section ($149) typically covers the drop from a first- or second-floor window to street level. Add sections as needed.
Three- to four-story walk-ups — Common in neighborhoods like Tremont, Williamsbridge, and Morris Park. A 25-foot section ($277) handles roughly two and a half stories in a single piece. Pair it with a 10-foot section for a full three-to-four-story run.
Five- to six-story prewar elevator buildings — Prevalent along the Concourse and in Fordham. A 50-foot section ($596) covers approximately five stories and can be extended with a 10-foot section to reach a sixth floor. Multiple 25-foot sections connected with carabiners work just as well if you want more flexibility.
Taller mid-rise buildings — For buildings of seven stories or more, combine sections. Every section connects to the next with the same loop-and-carabiner system, and the middle shortening straps let you fine-tune the total length on site.

Not sure how many sections you need? Count the floors from your highest work level to the dumpster, multiply by roughly 10 feet per story, and round up to the nearest section size. It's always better to have a little extra length than to come up short.

Setting Up the Chute on a Bronx Job Site

Setup is straightforward and requires no special tools or training:

Hang the top section from a window sill, roof parapet, scaffold pipe, or fire escape railing using the four woven loops at the top of the chute. Rope, bungee cord, or carabiners all work.
Connect additional sections below it loop-to-loop, making sure each joint overlaps by the built-in 1.5-foot overlap to keep debris contained.
Use the middle shortening straps to adjust the total hanging length so the bottom of the chute sits just above your dumpster or collection point.
Optional: remove the bottom from a standard 32-gallon commercial trash can and set it at the top of the chute as a funnel hopper. It catches debris thrown from the work area and channels it cleanly into the chute.
At the end of the day, disconnect sections, fold them flat, and store them on site or in your truck. The full 50-foot section folds down under 15 pounds.

Serving Every Bronx Neighborhood

EasyChute ships free to job sites across the Bronx — from Riverdale in the northwest to Co-op City in the northeast, from the South Bronx waterfront to the residential streets of Pelham Bay. Whether your project is a single gut renovation or a multi-unit building turnover, the chute ships directly to your site address.

Browse neighborhood-specific pages for setup tips relevant to local building stock:

Working across multiple NYC boroughs? See also the New York City debris chute overview, the Queens multi-unit guide, and the Brooklyn brownstone window setup page.

Order Your Bronx Trash Chute Online

Every EasyChute order ships free anywhere in the United States at fixed prices — no negotiating, no quote requests, no surprise freight charges. The fabric chute is reusable job after job, so the cost spreads across every project you run it on. Shop all chute sections and pick the size that fits your next Bronx job. Questions before you order? Call 855-902-4883 Monday through Friday, 8 AM to 10 PM Eastern, or email orders@easychute.com. You can also visit our FAQ page for quick answers on setup, section sizing, and connections.

Frequently asked questions

Does EasyChute ship free to job sites in the Bronx?

Yes. Free shipping is included on every order, and EasyChute ships to job site addresses anywhere in the United States, including all Bronx neighborhoods. Just enter your site address at checkout.

What section length do I need for a typical Bronx six-story apartment building?

A 50-foot section covers approximately five stories. For a six-story building, pair the 50-foot section with a single 10-foot section connected below it using the standard loop-and-carabiner system. The middle shortening straps let you fine-tune the final length on site.

Can I use EasyChute hanging from a fire escape in the Bronx?

The chute is designed to hang from a fire escape, window frame, roof edge, or scaffold railing using its four woven loops — no outrigger or frame required. Always confirm that attaching equipment to a fire escape is permitted under your building's rules and any applicable city regulations before you set up.

Is the chute compliant with OSHA rules for debris disposal in New York?

EasyChute meets or exceeds applicable OSHA regulations, including 29 CFR 1926.252(a), which requires an enclosed chute when material is dropped more than 20 feet outside a building's exterior walls. Check with your local building department for any NYC- or site-specific requirements.

Can I reuse the chute across multiple Bronx job sites?

Absolutely. EasyChute is built to be reusable job after job. After each project, disconnect the sections, fold them flat, and store them in your truck or on the next site. The tear-resistant woven coated-poly fabric is built for repeated use in construction and renovation work.

Trash Chute Bronx — Lightweight Debris Chutes Shipped Free to Your Job Site