Trash Chute Bay Ridge Brooklyn

Bay Ridge is one of Brooklyn's most distinctive neighborhoods — a stretch of tree-lined streets packed with brick row houses, two- and three-family homes, and the occasional pre-war apartment building climbing four or five stories above street level. When you're pulling out old plaster, tearing off a roof, or gutting a kitchen on the third floor, getting the debris down safely and cleanly is a real problem. A trash chute for Bay Ridge jobs solves that problem without cranes, outriggers, or a rental crew showing up with gear you didn't budget for.

EasyChute makes a lightweight, woven coated-poly debris chute that hangs from a window, a roof edge, or a fire escape and funnels material straight into a dumpster or trash can below. We ship free to job sites across Brooklyn — no minimum order, no freight surcharge, just the chute delivered to your address in Bay Ridge.

Trash chutes shipped free to Bay Ridge

Free shipping on every order. See the full shop.

EasyChute hung from a fire escape in Boston's North End, emptying into a junk removal truck

Why Bay Ridge Renovations Need a Trash Chute

The neighborhood's housing stock creates a specific set of site conditions that make manual debris hauling slow and risky. Most of the row houses and attached brick homes sit right up against the sidewalk with stoops that narrow the path to a front dumpster. Rear yards are often just wide enough for a small container, not wide enough for workers carrying armloads of drywall down a fire escape and squeezing past a neighbor's fence. And because the blocks are tight and residential, dropping material off a roof or tossing it from a window into a street container is exactly the kind of thing that draws a complaint — or an OSHA citation.

Under OSHA 29 CFR 1926.252(a), when construction material is dropped more than 20 feet to any point outside the exterior walls of a building, an enclosed chute must be used. A three-story Bay Ridge row house hits that threshold on the upper floor. EasyChute meets or exceeds that OSHA requirement, so you keep the job compliant without renting specialty equipment. Always check with the NYC Department of Buildings and your local building department on any additional permit or safety requirements for your specific project.

How EasyChute Works on a Bay Ridge Job Site

Setup is straightforward and doesn't require a second crew or special tools. Here's how it typically goes on a Bay Ridge renovation:

Pick your hang point. A window opening on the top floor, the roof parapet edge, or a sturdy fire escape landing all work. The chute's four woven connection loops at the top give you two front and two back attachment points — use carabiners or quick-connects to tie off to whatever's solid.
Build your hopper. A standard 32-gallon commercial trash can with the bottom removed drops right over the chute opening and acts as a funnel. Workers shovel or slide debris in; it travels down the chute and lands in your container at street level or in the rear yard.
Add sections as needed. Sections connect loop-to-loop with a 1.5-foot overlap at every joint, which keeps dust and debris contained inside the chute rather than drifting into the neighbor's yard or the street. Shortening straps in the middle let you fine-tune the length.
Break it down in minutes. When the job's done or you need to move, the sections unhook and fold down. A 10-foot section weighs under 3 pounds and fits in a drawer or small box. Bring it to the next job.

Choosing the Right Section Length for Bay Ridge Buildings

Bay Ridge's row houses typically run two to four stories, while some of the larger apartment buildings along the ridge reach five or six floors. Here's how to size your chute:

Two-story home (gut rehab, roofing, window replacement): A single 25-foot section ($277) covers roughly two and a half stories and handles most second-floor-to-ground drops cleanly.
Three- or four-story row house or two-family: Connect a Heavy-Duty 10-foot section ($149) above the 25-foot section to extend your reach. The heavy-duty sections are built for denser material like roofing shingles, old plaster, and dimensional lumber.
Five- or six-story apartment building: A 50-foot section ($596) covers five full stories in one run. For taller buildings, combine it with additional 10-foot sections to reach your specific drop distance.
Light demo or one-story additions: A Lite-Duty 10-foot section ($99) is a cost-effective starting point for shallow drops — single-story garages, shed demolitions, or low additions off the back of a Bay Ridge brownstone.

What You Can Put Through an EasyChute

EasyChute is built for common renovation debris: drywall and plaster, lath, roofing shingles, wood scraps, and insulation. The woven, coated poly fabric is tear-resistant and holds up through repeated use across multiple jobs. It is not designed for heavy concrete rubble, metal pipe, or sharp demolition material that could puncture the fabric.

Free Shipping to Bay Ridge Job Sites

We ship every order free anywhere in the United States — including directly to your job site on 86th Street, Shore Road, or anywhere else in the neighborhood. Order online and we ship it to you; there's no local storefront to visit and no delivery minimum to hit. If you have questions before you order, reach us by phone at 855-902-4883 (Monday through Friday, 8 AM to 10 PM Eastern) or by email at orders@easychute.com.

Bay Ridge and the Broader Brooklyn Job

If you work across multiple Brooklyn neighborhoods, EasyChute travels with you. The same sections you use on a Bay Ridge row house work just as well on a Park Slope brownstone, a Greenpoint loft build-out, or a Bushwick gut renovation. See our neighborhood guides for Park Slope, Greenpoint, and Bushwick, or browse the full Brooklyn debris chute overview. You can also read about hanging a chute from a brownstone window and why reusable chutes save money across NYC renovations.

Ready to order? Shop all EasyChute sections and get free shipping straight to your Bay Ridge job site.

Frequently asked questions

Can I hang an EasyChute from a Bay Ridge fire escape?

Yes — the four woven loops at the top of each section attach to any sturdy fixed structure, including a fire escape landing or railing, using carabiners or quick-connects. Make sure the attachment point can bear the load of debris moving through the chute, and check with your building department on any access or permit requirements before rigging off a fire escape.

What section length should I order for a three-story Bay Ridge row house?

A 25-foot section covers roughly two and a half stories. For a full three-story drop, add a Heavy-Duty 10-foot section above it to reach the upper floor. The sections connect loop-to-loop with a 1.5-foot overlap at each joint to keep debris contained.

Does EasyChute really ship free to Brooklyn?

Yes — free shipping is included on every order, no minimum purchase required. We ship to job sites across the United States, including anywhere in Bay Ridge or the broader Brooklyn area. Order online and the chute comes directly to your address.

Is a debris chute required by OSHA on a Bay Ridge renovation?

OSHA 29 CFR 1926.252(a) requires an enclosed chute when material is dropped more than 20 feet to any point outside the exterior walls of a building — a threshold you can reach on the upper floors of a typical Bay Ridge three- or four-story home. EasyChute meets or exceeds that OSHA requirement. For local permit or safety rules specific to your project, check with the NYC Department of Buildings.

Can I reuse an EasyChute on multiple jobs across Brooklyn?

Absolutely. The tear-resistant woven coated-poly fabric is designed for repeated use. A 10-foot section weighs under 3 pounds and folds down to fit in a small box, so it's easy to transport between a Bay Ridge job and your next site in Park Slope, Greenpoint, or anywhere else.

Trash Chute Bay Ridge: Move Renovation Debris Out Fast Without Blocking the Block